Learn how to properly mount a KeelShield keel guard to protect your Phoenix Bass Boat.
There are two ways to mount a keel protector on the Phoenix Boats depending on which model you have listed below. Both ways it is imperative that you use a bead of marine grade sealant (3M 4200 or equivalent) to seal up the leading edge once installed.
Mount the KeelShield as directly behind the start of the bottom wing and use a bead of marine sealant along the leading edge . We have always recommended starting the Shield 6″ above the resting waterline to avoid water pressure jamming on the leading edge of the adhesive while running with the nose down or in big water. On most of the Phoenix Boats you cannot start that high without going over a ribbed wing, hence our adjustment from the standard rule here.
We’ve had dealers and our Elite Series Pro, Hunter Shryock, mount it directly behind the bottom wing protrusion using sealant with great success. The lips on the wing acts like a small buffer and force the water pressure up and away from the leading edge of the adhesive – as shown on Hunters boat below:
XP & Pro Models
The KeelShield must be mounted by the standard instructions – start the shield a minimum of 6″ above the resting waterline and use sealant around the leading edge and the bends in the wings. Depending on the boat this can be directly below or to the top of the 2nd wing. All boats sit in the water a bit differently depending on model, engine, weight, etc.
We’re here to help!